Filter
Top Products
Replacement Procedures
4-38 Satellite P100 Maintenance Manual (960-Q02)
4.13 Touch pad
Removing the touch pad
The following describes the procedure for removing the touch pad (See Figure 4-22).
1. Peel off the glass tape and disconnect the touch pad flat cable from the connector on
the touch pad and peel the al foil.
2. Remove the following screws securing the touch pad plate.
• M2.5×3.0B SUPER THIN HEAD screw x7
3. Turning up the insulator, remove the touch pad plate.
4. Peel off and remove the touch pad from the cover assembly.
Figure 4-22 Removing the touch pad
Touch pad
Touch pad flat cable
Touch pad plate
M2.5x3.0
B
Touch pad board
M2.5x3.0
B
M2.5x3.0
B