Filter
Top Products
Replacement Procedures
4-56 Satellite P100 Maintenance Manual (960-Q02)
Installing the LCD unit/FL Inverter
The following describes the procedure for installing the LCD unit and FL inverter (See
Figure 4-31 to 4-34).
1. Install the LCD supports (LCD unit side) to the LCD and secure them with the
following screws.
• M2.0×3.0 BINK screw x4
2. Stand the LCD unit on the display cover and connect the LCD harness to the
connector on the back of LCD.
3. Stick the conductive tape on the connector of LCD harness.
4. Secure the LCD unit with the following screws.
• M2.5×4.0 BINK screw x6
5. Connect LCD harnesses to the connector CN1 of the FL inverter.
CAUTION: Be careful not to connect the LCD harnesses to the wrong connectors of FL
inverter.
6. Connect HV harnesses to the connector CN2 of the FL inverter.
7. Install the display mask while fitting the latches.
8. Secure the display mask with following screws
M2.5×6.0 BIND screw X4
9. Cover screws with Screw rubber cover X4
NOTE: When installing the display mask, make sure there is no gap between the display
mask and the display cover.