Filter
Top Products
43
English
Before Using
Preparations
Operations
Maintenance
Others
Remove the lamp cover.
Loosen the screw, put your fingers on the hollow, then pull up to
the direction of the arrow as shown in the figure to remove the
lamp cover.
Pull out the lamp.
Loosen the two lamp locking screws, and pull up the handle to
remove the lamp.
Mount the new lamp.
Align the orientation, press down the new lamp until it reaches to
the bottom, and lock it in place using the two lamp locking screws.
Replace the lamp cover.
Align the lamp cover, and press it in, then tighten the screws
loosened in Step 4 until the lamp cover is no longer loose.
Replace the tilt stand.
Put back the tilt stand using the reverse procedure to remove it.
(Continued)
1
2
2
1
2
1
2
1
Hollow