Filter
Top Products
13
USING THE PROJECTOR
This section describes how to use and make adjustments to the projec-
tor. It also provides a reference to the keypad and remote buttons and the
options available from the on-screen menus.
Basic Image Adjustment
1
Make sure you have powered up your equipment in the right order
(page 11).
2
If the image doesn’t display completely, zoom the image (page 15),
adjust the height of the projector (page 15) or center the image by
adjusting its horizontal or vertical position (page 22). Be sure the
projector is at a 90 degree angle to the screen.
3
If the image is out of focus, rotate the focus lens (page 15).
4
If the image appears to shimmer or if it has blurry vertical bars after
you have adjusted the focus, turn Auto Image (page 21) off and then
back on to reset the automatic sync and tracking. If that doesn’t clear
up the image, turn Auto Image off and adjust the sync (page 21) and/
or the tracking (page 22) manually.
5
If the colors don’t look right, adjust the brightness (page 19).
Using the Remote Control
The projector ships with a remote that has four function buttons, a disk
mouse and two mouse buttons, one on the top of the remote and one on
the bottom.
Point the remote control at the projection screen or at the front of the
projector. The range for optimum operation is about 25 feet. If you point
the remote at the projection screen, the distance to the screen and back
to the projector must be less than or equal to 25 feet. For best results,
point the remote directly at the projector.