Filter
Top Products
28
Maintenance & Troubleshooting
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you use the
remote. Symptoms of low battery charge include erratic responses when
using the remote and a reduced range of operation.
Follow these steps to replace the batteries:
1
Turn the remote face down in your hand.
2
Slide the battery cover off the end of the remote.
3
Remove the old batteries and dispose of them in an environmentally
proper manner.
4
Install two new AAA alkaline batteries. Make sure you install each
in the correct direction.
5
Slide the battery cover back on the remote.
Using the Kensington Lock
The projector has a Kensington Security Standard connector for use
with a Kensington MicroSaver Security System (Figure 19). See
“Optional Accessories” on page 35 for ordering information. Refer to
the information that came with the Kensington System for instructions
on how to use it to secure the projector.
F
IGURE
19
Installing the Kensington lock