Filter
Top Products
10
Chapter 4 Network
On Network page you can configure the IP address of the standalone EAP.
Figure 4-1 Network Page
Dynamic/Static:
By default, the EAP device obtains an IP address from a DHCP server (typically a
router). Select Static to configure IP address manually.
Fallback IP:
If the EAP fails to get a dynamic IP address from a DHCP server within ten
seconds, the fallback IP will work as the IP address of the device. After that,
however, the device will keep trying to obtain an IP address from the DHCP
server until it succeeds.
DHCP Fallback
IP/IP MASK:
Enter the fallback IP/IP mask.
DHCP Fallback
Gateway:
Enter the fallback gateway.