114
storm-control broadcast
Description
The storm-control broadcast command is used to enable the broadcast
control function. To disable the broadcast control function, please use no
storm-control broadcast command. Broadcast control function allows the
switch to filter broadcast in the network. If the transmission rate of the broadcast
packets exceeds the set bandwidth, the packets will be automatically discarded
to avoid network broadcast storm.
Syntax
storm-control broadcast [ rate rate ]
no storm-control broadcast
Parameter
rate —— Specify the bandwidth for receiving broadcast packets on the port.
The packet traffic exceeding the bandwidth will be discarded. By default, the
value is “128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the broadcast control function for port 5:
TL-SG3424(config)# interface gigabitEthernet 1/0/5
TL-SG3424(config-if)# storm-control broadcast
storm-control multicast
Description
The storm-control multicast command is used to enable the multicast control
function. To disable the multicast control function, please use no storm-control
multicast command. Multicast control function allows the switch to filter
multicast in the network. If the transmission rate of the multicast packets
exceeds the set bandwidth, the packets will be automatically discarded to avoid
network broadcast storm.
Syntax
storm-control multicast [ rate rate ]
no storm-control multicast