Filter
Top Products
123
User Guidelines
1. By default, the mapping relation between tag/cos and the egress queue is:
0-TC1, 1-TC0, 2-TC0, 3-TC1, 4-TC2, 5-TC2, 6-TC3, 7-TC3
2. Among the priority levels TC0-TC3, the bigger value, the higher
priority.
Example
Map CoS 5 to TC 2.:
TL-SG3424(config)# qos queue cos-map 5 2
qos queue dscp-map
Description
The qos queue dscp-map command is used to configure the mapping relation
between DSCP Priority and the CoS value. To return to the default configuration,
please use no qos queue dscp-map command. DSCP (DiffServ Code Point) is
a new definition to IP ToS field given by IEEE. This field is used to divide IP
datagram into 64 priorities. When DSCP Priority is enabled, IP datagram are
mapped to different priority levels based on DSCP priority mode; non-IP
datagram with IEEE 802.1Q tag are mapped to different priority levels based on
IEEE 802.1P priority mode if IEEE 802.1P Priority is enabled; the untagged
non-IP datagram are mapped based on port priority mode.
Syntax
qos queue dscp-map { dscp-list } { cos-id }
no qos queue dscp-map
Parameter
dscp-list —— List of DSCP value. One or several DSCP values can be typed
using comma to separate. Use a hyphen to designate a range of values, for
instance, 1,4-7,11 indicates choosing 1,4,5,6,7,11. The DSCP value ranges
from 0 to 63.
cos-id —— The priority level the packets with tag are mapped to, which ranges
from CoS 0 to CoS 7.
Command Mode
Global Configuration Mode