Filter
Top Products
79
logging file flash
Description
The logging file flash command is used to configure the level and the status of
the log file input. To restore to the default configuration, please use no logging
file flash command. The log file indicates the flash sector for saving system log.
The information in the log file will not be lost after the switch is restarted and can
be got by the show logging flash
command.
Syntax
logging file flash level
no logging file flash
Parameter
level —— Severity level of the log information output to each channel. There
are 8 severity levels marked with values 0-7. The smaller value has the higher
priority. Only the log with the same or smaller severity level value will be output.
By default, it is 4 indicating that the log information marked with 0~4 will be
saved in the log buffer.
Command Mode
Global Configuration Mode
Example
Enable the log file function and set the severity as 7:
TL-SG3424(config)# logging file flash 7
clear logging
Description
The clear logging command is used to clear the information in the log buffer
and log file.
Syntax
clear logging [ buffer | flash ]
Parameter
buffer | flash —The output channels: buffer and flash. Clear the information of
the two channels, by default.