TP-Link TL-SG3216 Switch User Manual


 
196
Change Aging Time to 80 seconds:
TL-SG3424(config)# cluster ndp timer aging 80
Change Hello Time to 80 seconds:
TL-SG3424(config)# cluster ndp timer hello 80
cluster ntdp
Description
The cluster ntdp command is used to configure NTDP globally. To return to the
default configuration, please use no cluster ntdp command. NTDP (Neighbor
Topology Discovery Protocol) is used to collect the NDP information and
neighboring connection information of each device in a specific network range.
It provides the commander switch with the information of devices which can join
the cluster and collects topology information of devices within the specified
hops.
Syntax
cluster ntdp
cluster ntdp timer {[ interval-time time ] [ hop-delay value ] [ port-delay
value ]}
cluster ntdp hop hop-value
no cluster ntdp
no cluster ntdp timer {[ interval-time time ] [ hop-delay value ] [ port-delay
value ]}
no cluster ntdp hop hop-value
Parameter
time —— NTDP Interval Time, which is the interval to collect topology
information. NTDP Interval Time ranges from 1 to 60 in minutes. By default, it is
1.
hop-delay value —— NTDP Hop Delay, which is the time between the switch
receiving NTDP request packets and the switch forwarding NTDP request
packets for the first time. NTDP Hop Delay ranges from 1 to 1000 in
milliseconds. By default, it is 200.
port-delay value —— NTDP Port Delay, which is the time between the port
forwarding NTDP request packets and its adjacent port forwarding NTDP
request packets over. NTDP Port Delay ranges from 1 to 100 in milliseconds. By
default, it is 20.