Filter
Top Products
142
Example
Create a MAC ACL whose ID is 23:
TL-SG3424(config)# mac access-list 23
access-list standard
Description
The access-list standard command is used to add Standard-IP ACL rule. To
delete the corresponding rule, please use no access-list standard command.
Standard-IP ACLs analyze and process data packets based on a series of
match conditions, which can be the source IP addresses and destination IP
addresses carried in the packets.
Syntax
access-list standard acl-id rule rule-id [ deny | permit ] [[ sip source-ip ] smask
source-ip-mask] [[ dip destination-ip ] dmask destination-ip-mask ] [ tseg
time-segment ]
no access-list standard acl-id rule rule-id
Parameter
acl-id —— The desired Standard-IP ACL for configuration.
rule-id —— The rule ID.
deny —— The operation to discard packets.
permit ——The operation to forward packets. It is the default value.
source-ip —— The source IP address contained in the rule.
source-ip-mask —— The source IP address mask. It is required if you typed
the source IP address.
destination-ip —— The destination IP address contained in the rule.
destination-ip-mask —— The destination IP address mask. It is required if you
typed the destination IP address.
time-segment —— The time-range for the rule to take effect. By default, it is
not limited.
Command Mode
Global Configuration Mode
Example
Create a Standard-IP ACL whose ID is 120, and add Rule 10 for it. In the rule,
the source IP address is 192.168.0.100, the source IP address mask is