Filter
Top Products
45
Gigabit Uplink Web Smart Switch
Clean Up
¾
: Clean up all members of the VLAN.
Submit
¾
: Submit to buildup a VLAN with the selected members.
Note:
VID of the VLAN must be unique and within the range of 1 to 4094.
At least two port members should be included to add a VLAN group. (If the page is
submitted with 0 VLAN member, it indicates to delete the VLAN.)
If any Trunk has been set, the Trunk can be configured as a VLAN member and
member ports of the Trunk cannot be configured (see Port 1 and 2 in Figure 6-40 for
example).
If the port is connected to a device that doesn’t support IEEE802.1Q (e.g. HUB and
some network adapter), value of the Egress Frame field should be set to “Drop Tag”.
For the first time the Port VLAN mode is set, a default VLAN, which is indexed as NO.
1 and contains all switch ports, will be built up.
The ports haven’t been assigned to any VLAN manually cannot communicate with
each other or other VLAN. That’s different from the Port VLAN.
The number of Port VLAN that can be set depends on the switch type. See the
Appendix C for details.
This page, which is designed to configure the uplink port, is displayed when the switch
is in MTU VLAN mode.
MTU VLAN SettingFigure 6-42
Note:
The uplink port will buildup several VLANs with each of the other ports. Each VLAN
contains two ports, the uplink port and one of the other ports in the switch, so the
uplink port can communicate with any other port but other ports can’t communicate
with each other.
First time the MTU VLAN mode is set, it set port 1 to be the uplink port by default.
This page contains the following fields:
Web Management