Filter
Top Products
47
Gigabit Uplink Web Smart Switch
Priority Mode
¾
: Contains “Disable”, “Port-Based” and “IEEE802.1p”.
Priority Rule
¾
: Contains “Weighted” and “Fixed”. If the priority mode is set to be
“Disable”, the priority rule cannot be configured.
This page is revealed when the “Port-Based” mode is configured. As shown below.
Port-Based priorityFigure 6-45
Port
¾
: Indicates the switch port number.
Priority Class:
¾
In port-based priority mode, the switch ports are classified into four
priority classes: lowest, lower, higher and highest. All the packets entering from the
port of the switch are forwarded in the correspondingpriority queue.
Further explanation:
When priority rule is configured as "weighted", a 1,2,4,8
weighting is applied to forward these four classes of packets.
This page is revealed when the “IEEE802.1p” mode is configured. When a switch port
receives an untagged frame (a frame without priority tag), the port's default priority
tag will be inserted into the frame before any other process.
Port Default PriorityFigure 6-46
Port
¾
: Indicates the switch port number.
Default Priority Tag
¾
: Indicates 802.1p tag being inserted into untagged frames.
Web Management