Filter
Top Products
TL-SL3428/TL-SL3452 JetStream L2 Managed Switch CLI Guide
122
Example
Specify the storm control rate as 2Mbps for port5:
TL-SL3428(config)# interface fastEthernet 1/0/5
TL-SL3428(config-if)# storm-control rate 2m
bandwidth
Description
The bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use no bandwidth
command.
Syntax
bandwidth { [ingress ingress-rate] [egress egress-rate] }
no bandwidth { all | ingress | egress }
Parameter
ingress-rate ——Specify the bandwidth for receiving packets. Range: 1-102400
for the megaport, 1-1024000 for the gigaport.
egress-rate —— Specify the bandwidth for sending packets. Range:1-102400
for the megaport, 1-1024000 for the gigaport.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Configure the ingress-rate as 5120Kbps and egress-rate as 1024Kbps for Fast
Ethernet port 5:
TL-SL3428(config)#interface fastEthernet 1/0/5
TL-SL3428(config-if)#bandwidth ingress 5120 egress 1024
clear counters
Description
The clear counters command is used to clear the statistic information of all the
Ethernet ports.