Filter
Top Products
Configuration Remote Unit System Information
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0 page 15
Remote Unit System Information
Log into the RU and the System Information page will appear. The user can change many of these parameters.
Note: When changing settings, it is usually necessary to click the Save and Activate Settings Button in order to
update the radio’s flash memory. If you do not, the setting will be lost the next time the radio is rebooted or power
cycled.
Table 2: Reference Table of Remote Unit System Information Parameters
Parameter Description Associated Page and Notes
Hardware Version
Hardware version is factory-set and cannot be
changed by user.
Permanent with Hardware
FPGA Version and
Checksum
These parameters provide information about
the current FPGA firmware loaded in the
radio.
Changes with FPGA upgrade. See
subsequent Release Notes on web site.
Firmware Version The Firmware version is the initial four
characters of this string. (i.e. 1p60 = 1.60 )
Changes with firmware upgrade. See
website for latest firmware version and
release notes.
Device ID
MAC address of the radio.
Permanent with Hardware
Opmode
Current operation mode of the radio. “On”
indicates transmitting. “Off” indicates not
transmitting.
Configuration page.
Note: in order to change radio from
Opmode “On” to Opmode “Off,” you must
change the default Opmode to “Off” and
reboot the radio.
Default Opmode Determines the Opmode (“ON” or “OFF”) of the
radio after reboot/power cycle. When the
parameter is set to “ON”, the radio will progress
into Opmode “ON” 30 seconds after
reboot/power cycle. Note: If radio startup is
interrupted within 30 seconds after reboot (by
opening a Telnet session) the radio will remain in
Opmode “OFF.”
Configuration page
CLI Command:
set defaultopmode [<on|off>]
System Up Time Time since radio was last rebooted or power
cycled.
Informational Parameter
Radio Temperature
Current internal temperature of radio.
Informational Parameter
[IP]
[subnet]
[gateway]
IP, subnet, and Gateway address of radio used to
manage the radio.
Configuration page
Note: Changing the IP of the radio could
cause loss of management connectivity.
CLI Command:
ipconfig [<ip> <subnet> <gateway>]
Master ID MAC ID of the MU that is associated to this RU. Informational Parameter
Status
Status of Master Unit: Connected (wireless
link established), or Disconnected (wireless
link not established).
Informational Parameter
RSSI
Relative Signal Strength Indicator. Displays
signal strength received from the RU to the
MU. A “?” indicates MU is not connected.
Informational Parameter
TFTPD Status TFTP daemon status (on or off). TFTPD should
be turned on to import a file (such as new
firmware) into radio’s TFTP buffer. Default is
off.
Configuration page
Note: This is used in firmware upgrade.
CLI Command
tftpd [<on | off>]
Telnet Port
User changeable telnet port of radio.
Configuration page
RF TX Power Transmit power of the RU not including antenna
gain. The RU’s transmit power will
automatically be adjusted to result in receive
signal strength at the MU to approximately
Informational Parameter