Filter
Top Products
Command Set Summary
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0 page 26
Appendix A Command Set Summary
• OFF = Opmode “OFF,” ON = Opmode “ON”
• s = serial, e = Ethernet
• + It may not work properly through HTTP’s command console.
Command Description OFF ON Remark
!+ redo the last command s s
? same as “help” se se
? <command> same as “help” se se
_password <new password>
<new password>
specify new password (max 15octs) se se
arp –bcast [<on | off>] enables/disables the sending of periodic arp
broadcast packets to gateway
se se
baud [<9600 | 115200>] display or set console baud rate se se default = 9600 bps
bye same as “logout” se se
eth <link | r | w | reset> display or set Ethernet setting se se
exit same as “logout” se se
freq display current channel se se
freq <ch#> <h | v> change current channel and polarization se se
freq channeltable display channel table se se
freq writechannel [<ch #>
<freq>]…
build channel and write to flash
<ch #> = 1..30
se se
heater [<on temp, 0..19> <off
temp, 1..20>]
set heater parameters se se
help display complete help page except “eng” se se
help <command> search and display command’s help se se
ipconfig [<new ip> <new subnet
mask> <new gateway>]+
assign radio’s IP, subnet mask, and
gateway IP
se se
logout logout of console se se
maclist macexp <30..600> change expiration time of MAC entry in
maclist
se se AP’s default is 600s
SU’s default is 30s
maclist filter [<on | off>] filter out all local Ethernet packets se se default: on
maclist [<reset>] display or reset current MAC table se se
msearch <sec> <ch#>
<h | v>…
Master search – RU will search for MU on
specified channel and polarization.
se
opmode [<on | off>] set or display current Opmode se se
password specify new password (max 15octs) s s
ping <ip address> ping local Ethernet device se se It only works for local
Ethernet devices, not
SU or any device behind
SU.
power display default and current TX power level se se default = +18 dBm
power <setism>
<min | max | dBm>
specify TX power for both band se se SU’s power will be
adjusted by MU when
association
ru ipconfig <new ip> <new
subnet> <new gateway>
assign Remote ipconfig se
ru ping ping Remote Radio se
ru powerleveling power levels RU to reach Target RSSI, set
in MU
se