Filter
Top Products
Command Set Summary
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0 page 27
Command Description OFF ON Remark
ru reboot reboot Remote Radio se
ru speedtest [<packet length>
<file size>]
perform speedtest
<pkt len> = 64..1760 bytes
<file size> = 10..100 Mbytes
se default:
<pkt len> = 1760 bytes
<file size> = 10 MBytes
ru sysinfo request Remote’s system information se
ru testrflink [<packet length>] perform RF loopback test testrflink
<pkt len> = 64..1760 bytes
se default:
<pkt len> = 1760 bytes
reboot reboot unit se se
remarks [<str>] string length should be 1 to 28 characters se se
reset [<all | 0…n>]… reset radio to the firmware default
n# = 0..2
Master:
0 - Channel Table, Active Channel = 1 h,
Switches, and Remarks
1 - TX Power = Max, RF Threshold = -90
dBm, Target RSSI = -60 dBm, MIR
Downstream = 10000 kbps, Upstream =
10000 kbps
2 - SNMP Community String (Read/Write)
= (public/private)
Remote:
0 - Channel Table, Active Channel = 1 h,
Switches, and Remarks
1 - TX Power = Max, RF Threshold = -90
dBm
2 - SNMP Community String (Read/Write)
= (public/private)
se
rfrxth <ism> <-90 | -85 | -80 | -
75 | -70 | -65>
specify RF RX Threshold se se default = -90 for both
band
rfrxthreshold … same as “rfrxth” se se
rssi display current RX RSSI se
save same as “updateflash” se se
save mm same as “updateflash mainimage” se se
save ss same as “updateflash systemsetting” se se
set defaultopmode [<on | off>] set or display default Opmode se se
set httpport [<port #>] set or display HTTPD port number se se default = 80
set mir [<downstream,
kbps>][<upstream, kbps>]
set or display MIR
<kps> = 100..10000
se se
set rssitarget <dB> set Target RSSI Threshold
It must be -45 to –75, and +5 dB higher
than RF RX Threshold.
se se
set snmpcomm [<read | write>] display or assign SNMP community string se se
set telnetport [<port #>] specify telnet port, <port #> = 1..65534 se se default = 23
ssrssi <ch #> <v | h> display RSSI on the current channel se
survey <ism> <time, sec> <h|v>
spectrum analysis of entire RF band se
sw 0 [<on | off>] set sw #0 – packet filter for
broadcast/multicast
se se default = on
sw 1 [<on | off>] set sw #1 – HTTPD service se se default = on
sw 2 [<on | off>] set sw #2 – Auto scan Master signal se se default = on
sw 3 [<on | off>] set sw #3 – Auto power leveling Remote
Unit
se se default = on
sysinfo display system configuration se se
temp display current temperature se se