TRENDnet BRF114 Network Router User Manual


 
Other Features and Settings
Figure 45: Routing Screen
Data - Routing Screen
RIP
Enable RIP
Check this to enable the RIP (Routing Information Protocol) feature
of the TW100-BRF114.
The TW100-BRF114 supports RIP 1 only.
Static Routing
Static Routing
Table Entries
This list shows all entries in the Routing Table.
The "Properties" area shows details of the selected item in the
list.
Change any the properties as required, then click the "Update"
button to save the changes to the selected entry.
Properties
Destination Network - The network address of the remote LAN
segment. For standard class "C" LANs, the network address is
the first 3 fields of the Destination IP Address. The 4th (last)
field can be left at 0.
Network Mask - The Network Mask for the remote LAN
segment. For class "C" networks, the default mask is
255.255.255.0
Gateway IP Address - The IP Address of the Gateway or
Router which the TW100-BRF114 must use to communicate
with the destination above. (NOT the router attached to the re-
mote segment.)
Metric - The number of "hops" (routers) to pass through to
reach the remote LAN segment. The shortest path will be used.
The default value is 1.
Buttons
Save
Save the RIP setting. This has no effect on the Static Routing Table.
Add
Add a new entry to the Static Routing table, using the data shown in
the "Properties" area on screen. The entry selected in the list is
ignored, and has no effect.
73