Tripp Lite 120/208V Power Supply User Manual


 
13
PlacetheUPSSysteminBypassModeorcompletelyturnitoff,
dependingonpreference.(Seesection5.4,Operation of Manual
Bypass Switch,or4.2,Turning the UPS Off.)
1
Removebatteryaccesspanel,locatedontheFRONToftheUPS
system.
2
2
DisconnecttheRED and BLACK cables attached to each internal
battery pack.
3
3
Remove the battery cartridge fuses from each fuse block.
Save the fuses.
4
4
DisconnecttheBLUE and WHITE jumper cables attached to each
fuse block.
5
5
CAUTION!
When disconnecting the jumper cables, pull
them straight away from the fuse block with
even force. Do not wiggle them side-to-side,
as this may damage the connector.
7. Adding or Replacing Internal Batteries
(
continued
)