Tripp Lite B004-2DUA2-K Switch User Manual


  Open as PDF
of 24
 
14
Hotkey Setting Mode
AllcongurationoftheKVM’ssettingstakesplaceinHotkey Setting mode. All
commands in Hotkey SettingmodestartbyenteringtheHotkey Setting Mode Activation
Command. When Hotkey Setting Modeisactivated,the[ScrollLock]and[CapsLock]
keyboardLEDsashinsuccessionandordinarykeyboardandmousefunctionsare
suspended.ThesectionthatfollowsdescribeshowtoactivateHotkey Settingmode,and
thecommandsthatcanbeperformedinit.Atableattheendofthissectionsummarizes
all of the commands.
Hotkey Setting Mode Activation Command
To activate Hotkey Settingmode,dothefollowing.
1. Pressandholddownthe[NumLock]key
2. Whileholdingdownthe[NumLock]key,pressandreleasetheminus[-]key
3. Afterreleasingtheminus[-]key,releasethe[NumLock]key
Alternate Hotkey Setting Mode Activation Command
The Hotkey Setting Mode Activation Commanddefaultsat[ScrollLock][-],butcanbe
switchedtouse[Ctrl][F12].Whenswitchedto[Ctrl][F12],the[Ctrl]keytakestheplace
ofthe[ScrollLock]key,and[F12]takestheplaceofthe[-]key.ToactivatetheAlternate
Hotkey Setting Mode Activation Command,performthefollowingsteps.Torevertbackto
thepreviouscommand,performthesestepsagain.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Pressandreleasethe[H]key
Alternate Port Switching Hotkey Command
Bydefault,thehotkeyproceedingsequenceusedinPort Switching Hotkeysis[Scroll
Lock][ScrollLock].Totogglebetween[ScrollLock][ScrollLock]and[Ctrl][Ctrl],dothe
following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Pressandreleasethe[T]key
Keyboard Operating System
TheB004-2DUA2-KandB004-2DUA4-Kdefaultkeyboardcongurationisforusewith
PCcompatiblekeyboards.IfyouhaveaMacorSuncomputer,youcanenablethe
KVMtoemulateMacorSunkeyboardcommands.Whenenabled,yourPCcompatible
keyboardcanbeusedtoperformcommandsspecictoMacorSun(SeetheKeyboard
Emulationsectioninthismanualfordetails).TosettheKeyboard Operating System,do
the following.
1. NavigatetotheportwhoseKeyboard Operating System setting you wish to change
2. Activate Hotkey Setting Mode using the aforementioned command
3. Pressandreleasethe[F2](forMac),[F3](forSun),or[F10](forAuto-Detect)key
WhenenabledforAuto-Detect,apass-throughkeyboardmodeisenabledinwhich
keystrokesaresentdirectlytothecomputerwithoutrstgoingthroughtheMacorSun
emulator.
Basic Operation
13-09-063-933242-EN.indd 14 9/10/2013 4:45:02 PM
 previous next