Tripp Lite SU1500XLCD Power Supply User Manual


  Open as PDF
of 96
 
10
Features
1
Input Cord:ThispermanentlyattachedpowercordconnectsyourUPStoapoweroutlet.
2
AC Receptacles (Varies by Model): Theseoutputreceptaclesprovideconnectedequipmentwithpuresine-waveACoutputduring
normal operation and battery power during blackouts and severe brownouts. Power provided at these outlets is filtered to protect
connectedequipmentagainstdamagingsurgesandlinenoise.Thereceptaclesaredividedintonumberedloadbanks,aslabeledon
the unit. Using PowerAlert software and cabling, load banks one and two may be individually turned off and on from a remote location,
allowinguserstoresetorrebootconnectedequipment.
3
Telephone or Telephone/Network Protection Jacks:Thesejacksprotectyourequipmentagainstsurgesoveratelephonelineor
telephone/networkdataline,dependingonmodel.Connectingyourequipmenttothesejacksisoptional.YourUPSwillworkproperly
without this connection. Note: Not compatible with PoE (Power Over Ethernet) applications.
4
Communications Ports (USB or RS-232): These ports connect your UPS to any workstation or server. Use with Tripp Lite’s PowerAlert
Softwareandincludedcablestoenableyourcomputertoautomaticallysaveopenfilesandshutdownequipmentduringablackout.
Also use PowerAlert Software to monitor a wide variety of AC line power and UPS operating conditions. Consult your PowerAlert Software
manual or contact Tripp Lite Customer Support for more information. The 9-pin RS-232 port also supports dry-contact communications.
See USB & RS-232 Serial Communications in the Optional Connections section for installation instructions.
5
EPO (Emergency Power Off) Port:YourUPSfeaturesanEPOportthatmaybeusedtoconnecttheUPStoacontactclosureswitch
to enable emergency inverter shutdown. See Basic Connection and Start-Up section for details.
6
Accessory Slot:RemovethesmallcoverpanelfromthisslottouseoptionalaccessoriestoremotelymonitorandcontrolyourUPS.
Visitwww.tripplite.comtoseeafulllistofaccessories,includingtheSNMPWEBCARDforremotecontrolandUPSmonitoring,andother
network management products.
7
Input Circuit Breaker: This resettable breaker prevents high input current from damaging the UPS or the attached load. If this breaker
trips, verify your UPS load before resetting the breaker switch in.
8
External Battery Pack Connector (configuration varies by model): YourUPSsupportstheuseofoptionalTrippLiteexternal
battery packs for additional runtime. An external battery pack is not provided. If you want to extend the runtime with an external battery
pack,contactTrippLiteCustomerSupportat773.869.1234fortheappropriateTrippLitebatterypacktoconnect.Refertoinstructions
available with the battery pack for complete information and safety warnings.
Note: The connector is protected by a cover plate held in place by two screws.
9
Ground Screw:Usethistoconnectanyequipmentthatrequiresachassisground.
10
Output Circuit Breakers Switches (Select Models Only):TheseresettablecircuitbreakersprotectyourUPSfromoutputoverload.
If one or both breakers trip, remove some of the load on the circuit(s) and allow the UPS to cool before pressing the breaker switch(es)
in to reset.
13-03-138 93-3168-EN.indd 10 3/28/2013 1:05:04 PM
 previous next