Filter
Top Products
20
http://www.TYAN.com
5. Replace the cabinet cover.
6. You can create or rebuild RAID for the hard disk drive (see chapter 6 for
information).
2.2 Adding a CD Drive
You will need to use a CD drive when installing an operating system and its
corresponding drivers (see chapter 3).
WARNING: You are advised not to make frequent connection and disconnection on the
IDE connector as this might cause damage to the data cable and connector pins.
CAUTION: Follow the instructions in this section carefully. The DVD or CD drive contains a
laser device. Do not attempt to open the DVD or CD drive’s enclosure or remove a DVD or
CD drive using any procedures other than those contained in this section to avoid the risk of
exposure to harmful radiation.
With a Secondary Ultra ATA/100 Hard Disk Drive Installed
1. Remove the cabinet cover (see the previous section in this chapter).
2. Unplug the data cable and power cord from the rear of the secondary hard disk
drive.
3. Connect the unplugged data cable (Œ) and power cord (•) to the rear of the CD
drive.