Filter
Top Products
81
http://www.TYAN.com
Reverse the above sequence when installing the new LCD module.
8.7 Replacing the Power Supply
To replace the system’s power supply, follow these procedures.
1. Remove the cabinet cover (see the previous section in this chapter).
2. Remove the secondary hard disk drive (see chapter 7 on Adding a Secondary Hard
Disk Drive).
3. Detach the 4-pin 12 V plug from the ATX 12 V connector on the motherboard as
well as the 20-pin connector from the ATX connector on the motherboard. Then,
remove the two screws.
4. Remove the two screws securing the power supply to the system’s rear panel.