Filter
Top Products
S1857 Trinity 371
19
!
important!
If you have been locked out of your system because you forgot your pass-
word or set the CMOS incorrectly, follow the instructions below.
1. Power off the system
2. Set jumper JP2 to pins 2 and 3
3. Wait for 2 seconds, then return jumper JP2 to pins 1 and 2.
4. Power on the system again.
By following this procedure, you will erase your password and reset the
CMOS to the BIOS defaults.
1-H Fan Speed Detect
When using Intels LANDesk system management software, you may monitor
the status of the CPU Fans by connecting them to the Fan1 connector. You
will NOT be able to monitor your CPU fan with the other Fan connectors.
1-I Soft Power Connector
The Soft Power Connector is part of
jumper block J16. The Trinity 371 uses
the chipset for power management,
including turning on and off the
system. If the Power Button Function
option in the BIOS Power Manage-
ment Menu is set to On/Off (which is
the default), pressing the power
button once after the BIOS has booted
up will turn the system on and off. If
the Power Button Function option is
set to Suspend, pressing the power
button once will wake the system or
send it to Suspend mode. In this case,
you cannot turn the system off unless
you shut down through the Windows
operating system or you hold the
power button down for four seconds.
1-J Sound disable (JP17)
By closing this jumper you will disable the on-board sound support which is
routed through the Creative Labs ES 1373 PCI sound chip.
The settings are closed (No onboard sound) or Open (Default).
1-K. Reserved Factory Header (J18)
This five pin header is reserved for factory settings in which future upgrades
INSTALL
FS0,FS1
(BUS
Speed)
CON3
(WOL)
J16
J12 (Speaker)
CON2
(WOR)
JP2 (Clr
CMOS)
JP17
(Sound
Enable)