Filter
Top Products
S1857 Trinity 371
31
INSTALL
Connecting Floppy Drives
Pin 1 on the floppy cable is usually denoted by a red or colored stripe down
one side of the cable (see Figure 2-20 below). Most of the current floppy drives
on the market require that the colored stripe be positioned so that it is right
next to the power connector. In most cases, there will be a key pin on the cable
which will force you to connect the cable properly.
Drive A: is usually attached to the end of the cable with the twist in it. Drive B:
is usually connected to the middle of the cable. Refer to your installation
instructions or call your dealer if you are unsure about attaching floppy drives.
Figure 2-19
Figure 2-20