Filter
Top Products
S1857 Trinity 371
27
To attach the retention module, place the motherboard on a flat surface. Locate
the key pin on one end of the CPU slot on the board. Then carefully line up the
key notch on the retention module with the key pin on the CPU slot(the key
pin on the CPU slot indicates the correct orientation of the CPU) See Figure 2-
11 on the previous page.
Drop the retention module (Figure 2-12
right) down over the CPU slot so that
the retention module sits flat against the
motherboard. Secure the module with
the pins or screws provided.
Figure 2-14 below shows a side view of a retention brace securing both sides
of the SECC2 CPU. When both sides are properly positioned, press both
braces against the sides of the CPU and carefully lift them over the CPU slot
on the motherboard.
Figure 2-13
Figure 2-14
Figure 2-12
INSTALL