Filter
Top Products
Global Settings
ETV Portal Server Admin Guide 45
3. In Select VBrick, select one or more existing VBricks for which a SAP has been received.
If you select one VBrick, this populates the VBrick Configuration panel. (If you select
multiple VBricks, it does not populate the panel; if you need to configure the VBricks,
you must add them one at a time.)
4. Complete or modify the fields in
VBrick Configuration as necessary. Note that you must
enter a User Name and Password and
confirm that Password or the configuration will
fail.
5. Click Submit when done. This adds the new configuration to the list of configured
VBricks shown on the previous page.
Note The only time you will manually complete the VBrick Configuration fields is when you
are defining the configuration for a VBrick that will be added to the network at a later
time. In this case, you will need to know the following configuration data in advance.
Host Name Required. Host name of VBrick.
IP Address Required. IP address of VBrick.
User Name Defaults to system-defined value if blank.
User Password Defaults to system-defined value if blank.
Confirm Password Defaults to system-defined value if blank. Must match User
Password if entered above.
Software Revision Optional. To get the Software Revision, use IWS (for MPEG
and WM) or VBAdmin (for H.624).
HTTP Port Optional. To get the HTTP Port, use IWS (for MPEG and
WM) or VBAdmin (for H.624).
VBrick Model Select from the dropdown. Advanced settings are enabled if
you select an encoder or a VBStar.