Omni 3300 Installation Guide
10
Ports for Attaching Optional Peripherals Devices:
In the center are two RJ45-type modular jacks (serial ports):
• The “RS232” serial port (icon shown at right)
connects a VeriFone CR 600 check reader or
other peripheral device.
• The other serial port (identified by “Bar Code”
and “PIN Pad” icons at right) connects a PIN
pad, smart card reader/writer, or bar code
wand.
Power Connection Port
• On the lower right is a round port with a lock
notch for securely connecting the terminal to a
power source (identified by the “electrical
power” icon at right).
Step 4: Connect the Terminal to a Telephone Line
Refer to Figure 4, page 11:
1. Direct connection — A telephone cord runs
from the Telco port on the terminal directly to a
telephone wall jack. With a direct connection,
the line is dedicated to the terminal.
2. Pass-through connection — A telephone cord
runs from the Telset port on the terminal to the
RJ11-type jack on a standard telephone. With a
pass-through connection, the line is busy
during terminal downloads.
Caution: For the pass-through connection, do not lift the
telephone handset during a transaction. Doing so may disrupt
the carrier signal and cause the transaction to fail.
O3300 InstallGuide.book Page 10 Thursday, November 25, 1999 3:48 PM