Filter
Top Products
Installation
24 Vidikron Vision Model 120 Owner’s Operating Manual
PRE
L
IMINAR
Y
6. Lock the lens in place by turning the Lens
Locking Nut (to the left of the lens) 180
degrees counter-clockwise. (Use a
6.0mm hex wrench.)
7. Remove the Front Lens Cap.
8.Replace the Lens Cavity Front Cover.
9. Re-install the Projector Front Jewelry.
Tighten the hex screws at the top and
bottom of the jewelry to secure it.
3.5
Installing the Optional
CineWide Lens Mount
If you are installing a standard (non-CineWide) Vision 120, skip this step and proceed with
Mounting the Vision 120 (page 30).
If you are installing a Vision 120/CineWide, proceed with Installing the Fixed CineWide Base
Plate (Vision 120/CineWide) (page 29).
If you are installing a Vision 120/CineWide with AutoScope, proceed as follows to install the
AutoScope lens motor.