Filter
Top Products
Installation
40 Vidikron Vision Model 120 Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting to AC Power Projector/VHD Controller: Plug the female end of one power cord into the AC receptacle on
the rear of the Vision 120 (AC 100V ~ 240V). Then, connect the other end to your AC power
source.
Similarly connect the VHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is
provided for the lens motor. Plug the female end of the AC power cord into the AC input on
the rear of the lens motor assembly. Connect the other end to a 110
VAC power source.
3.8
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch at the rear of the VHD Controller.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear of
the AutoScope lens motor. The lens motor power switch is located next to the AC input
(see
Figure 3-17).
4. Press the ON button on the remote control – or the SOFT PWR button on the VHD
Controller front panel – to turn on the system. The vacuum fluorescent display on the
VHD Controller front panel briefly displays “Starting Display.”
5. When the projector is ready for use (after about 20 seconds), the RUN LED on the VHD
Controller front panel lights solid blue. The fluorescent display indicates the current
input source, aspect ratio and input resolution; for example:
3.9
Adjusting the Picture
Orientation
By default, the Vision 120 is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or inverted,
you must change the picture orientation. To do this:
1. Press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
3. Select Display Device from the Service Menu.
4. Select Installation from the Display Device menu.
5. Choose Floor Rear, Ceiling Front or Ceiling Rear, to match the installation method.
➤
The input voltage to the AutoScope lens motor must be between 100 and
120 VAC. Do not connect the AutoScope lens motor to a 200-240
VAC
power source!
Caution
V120 Component RCA
16:9 480I
Current Input Source
Aspect Ratio Input Resolution