Filter
Top Products
38
Controlling the projector through a LAN environment
You can manage and control the projector from one or more remote computers when
they are properly connected to the same local area network.
Wired connection
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the
projector and the other end to the RJ45 port on your Ethernet or router.
2. Press MENU/EXIT on the projector or Menu on the remote control and then go to
Setting > Lan Control Setting menu.
3. Highlight Wired LAN and press ENTER on the projector or Enter on the remote
control.
4. Make sure the Status is Connect.
5. Press to highlight DHCP and press / to select On.
6. Press to highlight Apply and press ENTER on the projector or Enter on the
remote control.
7. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page.
The Projector IP Address, Subnet Mask, Default Gateway, and DNS Sever
settings will be displayed. Note down the IP address displayed in the Projector IP
Address row.
Important
•
If the Projector IP Address still does not appear, contact your network administrator.
• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
• If you wish to connect to the projector in its standby mode, be sure you have selected
RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information
when the projector is on.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
to highlight DHCP and press / to select Off.
3. Contact your ITS administrator for information on the Projector IP Address,
Subnet Mask, Default Gateway, and DNS Sever settings.
Internet
IP Router