Filter
Top Products
PJL9371ViewSonic 42
OPTION menu
OPTION menu
From the OPTION menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons,
and press the ► cursor (or the ENTER) button to
execute the item, except for the items LAMP TIME
and FILTER TIME. Then perform it according to the
following table.
Item Description
AUTO SEARCH
Using the ▲/▼ cursor buttons turns on/off the automatic signal
search function.
ON
ó
OFF
When the ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from
the current port. Then when an input is found, the projector will stop
searching and display the image.
COMPUTER IN1
ð
COMPUTER IN2
VIDEO
S-VIDEO
COMPONENT (Y, Cb/Cr, Cr/Pr)
AUTO
KEYSTONE
Using the ▲/▼ cursor buttons turns on/off the automatic keystone
function.
ON
ó
OFF
ON : Automatic keystone distortion correction will be executed
whenever changing the slant of the projector.
OFF : This function is disabled. Please execute the AUTO
KEYSTONE (EXECUTE) in the SETUP menu for automatic
keystone distortion correction.
• When the projector is suspended from the ceiling this feature will
not function properly so select the OFF.
• This function will be unavailable when the Transition Detector is
on.
DIRECT ON
Using the ▲/▼ cursor buttons turns on/off the DIRECT ON function.
ON
ó
OFF
When set to the ON, the lamp in projector will be automatically
turned on without the usual procedure, only when the projector is
supplied with the power after the power was cut while the lamp was
on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
•
After turning the lamp on by the DIRECT ON function, if neither
input nor operation is detected for about 30 minutes, the projector is
turned off, even though the AUTO OFF function is disabled.
(continued on next page)