Filter
Top Products
SETTING UP YOUR SCANNER TO WORK WITH PAPERPORT 131
SETTING UP YOUR SCANNER TO WORK WITH
P
APERPORT
When you selected a scanning option from the Scanner drop-down list,
such as TWAIN: Visioneer Strobe XP, the Scan button at the bottom
of the panel should become active after approximately 5 to 10 seconds.
If it doesn’t, you need to set up your scanner to work with the selected
option.
Note: Setting up your scanner is a one-time-only process for each
option from the Scanner drop-down list. Therefore, you may have to
set up your scanner once each for TWAIN: Visioneer Strobe XP and
WIA: Visioneer Strobe XP. The setup process, described below, is the
same for each option. You will not have to set up the scanner again for
an option unless you uninstall the scanner and PaperPort software,
then re-install them.
If this Scan button is not active,
you need to setup your computer.