Filter
Top Products
- 9 -
www.vivotek.com
Item LED status Description
LED1 and LED2 blink alternately by 150ms During the test
LED1 blinks one time and LED2 blinks 3 times TM1302 test fail
Power-On-Self-Test
LED1 blinks one time and LED2 blinks 4 times RTL8100BL test
fail
LED1 off, LED2 off Network fail Network
LED1 blink every 0.5 second, LED2 off Network normal,
Heartbeat
Camera control LED2 blink every 1 second Get the control
message
BNC video inputs
Video Server allows up to four cameras attached at the same time. To ensure video
modulation type being detected correctly, cameras should be attached sequentially from
“VIDEO1” to “VIDEO4” and powered on before Video Server is powered on.
DIP switches “1” to “4”
There are four DIP switches numbered from “1” to “4” in the front panel regarding of
each video input. They are used to enable the 75-ohm resistance of video impedance.
They should be kept ON if the video input is terminated in the Video Server or left in high
impedance for looping.
Auxiliary button “RESET”
There is a button located at the left of “VIDEO4” in the front panel. Refer to the Appendix
Troubleshooting
for the detailed usage of system recovery.