Filter
Top Products
- 8 -
www.vivotek.com
Physical Description
Front Panel
Status LED’s
NET SYS
Tx/Rx
Power
Link
10/100
LED1
(Heartbeat)
Full duplex
LED2
(Status)
Each time Video Server starts up, it will perform power-on-self-test, abbreviated as POST,
to examine every hardware module. As soon as the administrator plugs in the power
connector both LED’s under the power LED will flash one by one until the diagnosis is
done. If the result is good, both status LED’s will turn off for a while and then follows the
pattern below. If any module fails, refer to the Appendix A for the error pattern and
follow the trouble-shooting procedures. If the system still cannot operate normally,
please contact your reseller for technical service.