Filter
Top Products
B90-36R305
Bus-Powered USB ADSL Modem
Installation and User Guide
PN 030-300118D 39
Macintosh Hardware Installation
Cable Connections
IMPORTANT! Do NOT connect the USB modem to the computer until instructed to do
so in the software driver installation procedure for your operating system.
1.
Insert the flat rectangular end of the USB cable into the USB port on your computer. The figure below shows
the basic cable connections.
POWER
READY
USB CABLE
Figure 66. ADSL Modem Cable Connections
2.
When instructed to do so by the installation process, insert the square end of the USB cable into the USB port of
the ADSL modem. The green POWER LED indicates that it has been plugged in correctly and that the power is
ON
.
3.
Plug a telephone cable into the ADSL/Line connector and into a standard RJ-11 telephone jack.
4.
When the modem is physically connected, the Plug and Play program will recognize the USB modem and install
the hardware drivers.
Macintosh Hardware Note
: The USB modem must be plugged into a USB port on
the computer itself or a powered hub, not into keyboard port.
!
!