Westell Technologies B90-36R305 Modem User Manual


 
B90-36R305
Bus-Powered USB ADSL Modem
Installation and User Guide
PN 030-300118D 54
R
EGULATORY
I
NFORMATION
FCC COMPLIANCE NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Power the equipment from an outlet on a circuit other than circuit powering the receiver
Consult the dealer or an experienced radio/TV technician for help.
PART 68 – EQUIPMENT REGISTRATION
This equipment (ADSL modem) also complies with Part 68 of the FCC rules. A label on the bottom of this equipment
contains, among other information, the FCC registration number and ringer equivalence number (REN) for this
equipment. If requested, this information must be provided to the telephone company.
This equipment is designated to be connected to the telephone network or premises wiring using a compatible modular
jack which is Part 68 compliant. An FCC compliant telephone cord and modular plug is provided with the equipment.
See the installation instructions for details.
If this terminal equipment (ADSL modem) causes harm to the telephone network, the telephone company may request
that you disconnect the equipment until the problem is resolved. The telephone company will notify you in advance if
temporary discontinuance of service is required. If advance notification is not practical, the telephone company will
notify the customer as soon as possible. You will be advised of your right to file a complaint with the FCC, if you
believe such action is necessary.
The telephone company may make changes to their facilities, equipment, operations, or procedures that
could affect the operation of this equipment. If this happens, the telephone company will provide advance
notice in order for you to make the modifications necessary to maintain uninterrupted service.
If you experience trouble with this equipment (ADSL modem), do not try to repair the equipment yourself.
The equipment cannot be repaired in the field and must be returned to the manufacturer. For instructions on
product return contact your service provider.
This equipment cannot be used on public coin phone service provided by the telephone company.
Connection of this equipment to party line service is subject to state tariffs.
CANADA CERTIFICATION NOTICE
The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal
Equipment Technical Requirements document(s). The department does not guarantee the equipment will operate to the
user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
Telecommunications Company. The equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.