Filter
Top Products
030-300411 Rev. A 47 July 2004
Westell (Models 6000, 6100, 6110)
User Guide
11. CONFIGURATION (MODEL 6100)
11.1 VC Configuration
The following settings will be displayed if you select VC Configuration from the Configuration menu.
NOTE: The actual information displayed in this screen may vary, depending on the network connection established.
NOTE: If you experience any problems, please reset your Router via the external hardware re-set button or via the
procedure defined under the Maintenance menu.
Status Allows you to enable or disable your VC (Virtual Connection)
VPI Displays the VPI (Virtual Path Indicator) value for a particular VC, which is
defined by your Service Provider.
VCI Displays the VCI (Virtual Channel Indicator) value for a particular VC,
which is defined by your Service Provider.
Protocol
NOTE: The configuration
specified by your Service
Provider will determine which
Protocols are available to you.
Displays the Protocol for each VC, which is specified by your Service
Provider.
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer
Mode). This is an ATM encapsulation of the IP protocol.
Bridge Broadcast
Factory Default = CHECKED
When this setting is CHECKED, the Router will allow Broadcast IP packets
to/from the WAN.
When this setting is NOT CHECKED, the router will block Broadcast IP
packets to/from the WAN.