Filter
Top Products
6-6
IPS-800/1600-D20 Series - User’s Guide
6.2.3. Applying Commands to Several Plugs -
Text Interface
As described below, switching and reboot commands can be applied to only
one Switched AC Outlet, or to an assortment of outlets.
Note: When switching and reboot operations are initiated, Boot/
Sequence Delay times will be applied as described in Section 5.3.3.2.
1. Several Plugs: To apply a command to several plugs, enter the numbers
or names for the plugs, separated by a "plus sign" (+). For example to
switch plugs 1, 3, and 4 Off, enter the following:
/OFF 1+3+4 [Enter]
2. Series of Plugs: To apply a command to a series of plugs, enter the
number for the plugs that mark the beginning and end of the series,
separated by a colon. For example, to switch plugs 1 through 3 On, enter
the following:
/ON 1:3 [Enter]
4. All Plugs: To apply a command to all plugs, enter an asterisk in place of
the name or number. For example, to Boot all plugs, enter the following:
/BO * [Enter]
6.3. Logging Out of Command Mode
When you have finished communicating with the IPS, it is important to always
disconnect using either the "Log Out" button (Web Browser Interface) or /X
command (Text Interface), rather than simply closing your browser window or
communications program.
When you disconnect using the Log Out button or /X command, this ensures
that the IPS has completely exited from command mode, and is not waiting for
the inactivity timeout period to elapse before allowing additional connections.