Filter
Top Products
7.2. Restoring Saved Parameters
This section describes the procedure for using ProComm to send
saved parameters to the RPC-4840N.
1. Start your communications program and access the
RPC-4840N command mode using the System Level
Password.
2. Configure your communications program to upload an
ASCII text file.
3. Upload the file with the saved parameters. If necessary,
key in the file name and directory path.
4. When the upload is complete, make certain to terminate
the communications program's upload mode.
Note:
·
The current On/Off status of each RPC-4840N
circuit will not be saved or restored. However, the
selected default On/Off setting for each circuit will
be saved and restored.
·
When the configuration file is sent to the
RPC-4840N via telnet, the unit's IP Address,
Subnet Mask, and Gateway Address cannot be
altered.
5. Type /SP and press [Enter], the RPC-4840N will display
the Status Screen with passwords revealed. Check the
Status Screen to make certain that saved parameters have
been restored.