Filter
Top Products
Installation
2–12 975-0131-01-01
Conduit
holes/knockouts
Pre-plan the wire and conduit runs. Knockouts for 1.9 cm (3/4 inch) or 2.5 cm
(1 inch) conduit holes are located on the bottom and back of the wiring box.
Threaded 3/4” conduit holes are located on each side of the wiring box
(Figure 2-5).
For maximum safety, run AC, DC, and communication wires in separate conduits.
Planning AC Wire Routing
AC connections include all the wires and connectors between the GT Inverter AC
terminals and the main utility service panel. Pre-plan these routes carefully before
installing the components.
Planning DC Wire Routing
DC connections include all the wires and connectors between your PV array and
the DC terminals of the GT Inverter. Pre-plan these routes carefully before
installing the components.
Figure 2-5
Knockout Locations on Bottom of Wiring Box
WARNING: Shock hazard
Check for existing electrical or plumbing prior to drilling holes in the walls.
1.9 cm (3/4”) or 2.5 cm (1”) Knockouts,
also on back of Wiring Box
AC/DC Disconnect Switch
Front of Wiring Box
Left side
Right side
Back of Wiring Box
1.9 cm (3/4”) Threaded
Conduit Holes