Filter
Top Products
Operation
3-18 975-0162-01-01
Jump-Starting a Vehicle’s Engine
You can use the XPower Powerpack to jump-start a vehicle
or boat engine that has a 12-volt starting battery using the
Jump-Start cables supplied with the unit.
WARNING: Fire hazard
Never allow cables’ red and black clamps to touch each other or
another common metal conductor. This could cause damage to the
unit and/or create a sparking/explosion hazard. Always disconnect
the clamps for the unit after use and clip the plastic guard over the
jump-start cable port.
WARNING: Fire hazard
Jump-start cable clamps’ connection to the vehicle’s battery
terminals must be positive to positive (red clamp to battery “+”)
and negative to negative (black clamp to battery “-”). A reverse
polarity connection (positive to negative) may cause damage to the
unit and/or create a sparking/explosion hazard.
WARNING: Risk of explosion, fire or burns
The battery terminals exposed at the Jump-Start Cable Port have
enough energy present to cause a spark, creating an explosion
hazard, or to cause burns if a metal object contacts both terminals.
Always clip the plastic guard over the Port when not in use.
WARNING: Fire hazard
The jump-start feature is designed for short term operation
only—less than 4 seconds. Operating the jump-start feature for
more than 4 seconds may cause damage to the unit. Allow the
XPower Powerpack to cool down for at least 3 minutes after each
jump-start.
Important: Closely follow these instructions for jump-starting
your vehicle as they may be different from the instructions
supplied with other jump-start products or jump-start cables.
975-0162-01-01_Rev-C.book Page 18 Friday, October 20, 2006 10:40 AM