Filter
Top Products
Xerox Nuvera™ 100/120 Digital Copier/Printer Customer Expectations Document
- 25 -
SPECIAL STOCKS
Transparencies
The tray capacity for removable stripe transparencies and Mylar reinforced sheets is 90. There is no constraint
for feeding painted striped transparencies or stripeless transparencies.
Carbonless
Xerox Carbonless Papers as listed earlier in this document are the only recommended carbonless media. Only
simplex printing is supported on this stock type.
Running carbonless paper may require additional cleaning time
by the CSE during service of the machine. This time will vary based on the percentage of carbonless stock run.
In the 100% carbonless usage case, service time could be up to 60 additional minutes per service call at
150,000 prints
DocuCards®
DocuCards® can only be loaded 100 at a time in a tray. Nuvera feeder trays feed until almost empty but not
until empty, leaving 20~40 sheets remaining. When running DocuCards®, frequent reloading of the feeder trays
will be required.
DocuCards® can only be run to the Top Tray of the finisher. Some mis-stacking may
occur as the DocuCards® catch on the edges of the stacked sheets. ®.
Reinforced stocks
Reinforced stocks should be limited to less than 90 loaded in a tray at one time.
Tab Jobs
Jobs must be run with reverse collated tabs.
Running tabs requires proper use of the supplied Tab Guides.
Tab stock sizes supported are: Letter, 9"x11", 9.5”x11”, A5, A4.
Tabs are supported when the number of segments is 10 or less.
Images printed on Mylar tabs are typically degraded by toner scatter.
Envelopes
Envelopes should be limited to 60 loaded in a tray at one time. Nuvera feeder trays feed until
almost empty but not until empty, leaving 20~40 sheets remaining. When running envelopes
frequent reloading of the feeder trays will be required.
Very slight wrinkles (1/2 inch long) may occur on the trail edge of envelopes at the corners.
Due to the nature of feeding envelopes with flap open, some mis-stacking may occur in the top tray as the
envelopes catch on the open flaps.
Envelopes should be sent to the Top Tray only, with a maximum limitation of 15.
Drilled Paper & Tab Jobs
Currently most jobs are delivered face down, with the bind edge trailing to match the requirements of the
finisher. When tabs are run to the MFF, the tabs must be delivered with the tab leading and this requires an
inversion at the exit of the paper path and entrance into the finisher. It is quite common to run drilled paper
when running tabs jobs, and this requires the user to reverse the loading of the drilled body stock in the tray
such that the drilled edge is opposite what the paper tray loading label for drilled body stock shows.
2-tray LFSFM