Filter
Top Products
Xerox Nuvera™ 100/120 Digital Copier/Printer Customer Expectations Document
- 28 -
Text Quality
Black text quality is excellent for sizes as
low as 4 point.
Line Quality
The Xerox Nuvera™ 100/120 Digital
Copier/Printer can print solid lines all the
way down to 70 microns.
Mylar Tabs
Toner scatter typically degrades images
printed on Mylar Tabs.
Area Coverage
The Xerox Nuvera™ 100/120 Digital
Copier/Printer uses nested automated
controls of dry ink, development, tone
reproduction, and the internal
environment to assure consistent
printing. These closed loop process
controls continuously test against the
targets and adjust as required.
The control system is designed to run
within a specific range of quality.
Although some variation may be
noticeable in specific cases, the closed
loop controls will typically deliver very
acceptable quality, consistently,
predictably, and without operator
intervention.
Other artifacts
As with any printing process, artifacts may
occur on the Xerox Nuvera™ 100/120
Digital Copier/Printer. These include
streaks, mottle, banding, spots and edge
deletions. For most jobs and clients, the
expected level of artifacts is within the
normal operational and component quality
ranges of the system and will not affect the
acceptability of the job.
Using Xerox stocks and maintaining
your environment will help to minimize
the occurrence of these artifacts.
-
Print to Edge
This is not a print to edge system due to potential image quality defects on the edge of the page.
The system default is set for a 3 mm border erase. It can be set to 0 mm, but it is subject to image
quality limitations, which may be acceptable for some applications.
Some non-standard and custom paper sizes may have a larger border region where image quality
cannot be optimized.
-
SRA3 Printing
Printing on SRA3 can result in inboard and outboard edge image quality defects. The defects can
range from slight mottle to high contrast deletions depending on the type and condition of the
substrate being printed on. The reason for this is that the Transfer Assist Blade does not completely
extend to the edges of SRA3 substrates. The blade does not make contact with the last 14mm at
both the inboard and outboard edges of SRA3 substrates.
-
Area Coverage
The system is capable of continuous printing of pages up to 33% area coverage. When documents
that exceed 33% area coverage per page are continuously printed, the customer may notice that
the system does not print at the rated speed.
-
Xerographic Color Prints
Xerographic color originals cannot be run through the fuser.