Filter
Top Products
FUNCTION SELECTION VIA LINE (FSL) COMMANDS
3. Save the setting using the command <ESC> <X1>.
FSL types
All FSL commands begin with a leading escape character:
• T—Test functions
• W—Bar Code printing
• X—Memory exchange
• Y—Setup functions
• Z—Sending of user strings.
Only FSL command types W and Y end with a trailing escape
character.
General syntax of an FSL command
The general syntax of an FSL command is as follows:
<ESC> <FSL type> <function no.>, <parameter> <ESC>
Between the leading and the trailing escape characters, all blanks
and IBM control codes are ignored. Thus, you could insert
blanks to make the strings easier to read. The escape sequence
specifies the function you wish to activate and the value that
should be attached to the function.
FSL commands
Table 3-2. FSL Commands
FSL Command name
ESC Special Transparent Feature (Single Paired
Hex Transparent
ESC-ESC Special Transparent Feature (Multiple Paired
Hex Transparent
T1 Offline Hex Dump (PCIA Dump)
T2 Online Hex Dump
T3 Online ASCII Hex Dump
T4 Printout Settings
T5 Printout Character Set
T6 Cancel Online ASCII Hex Dump
W Print Bar Code
X0 Set Printer in Hold Mode
X1 Store Settings in Permanent Storage
X2 Restore Settings from Permanent Storage
X3 Restore Factory Default Settings
XEROX MRP FAMILY COAX COMMAND REFERENCE 3-5