Filter
Top Products
FUNCTION SELECTION VIA LINE (FSL) COMMANDS
Y6—Set Default Maximum Print Position (MPP)
@Y6, n@
Selects current and default maximum print position (MPP) in
characters from the left margin. The factory default setting is
132.
n Valid parameters are:
000—255 Set MPP in number of characters
Default setting is 132.
This function emulates a front panel switch on an IBM printer. It
has an immediate effect.
MPP and the current position are not changed by changing
characters per inch (CPI).
Remember When set at 000, no horizontal formatting is done; no new line
(NL) is generated by the interface at MPP even if MPP is defined
by the data stream.
Refer to the “Set Print Density (SPD)” section of the “DSC and
SCS data stream commands” chapter for additional information
on this SCS command that impacts this FSL Y6 function.
Example @Y6, 80@ sets MPP to 80 characters.
Y7—Set Case (mono, dual)
@Y7, n@
Selects mono case or dual case as the power-up default setting
for the printer. The factory default setting is dual case.
n Valid parameters are:
0 Mono case (left to right)
1* Dual case (left to right)
2 Right to left (Dual case)
3 Left to right (Dual case).
In mono case, printing is in upper case characters only. Printing
in dual case includes upper and lower case characters. This
function can only be overridden from the system if you use value
0 or 1.
On the PCL/IPDS platform, values 2 and 3 are supported as Left
to Right (dual case). Y7 is used only in DSC LU3 mode and
ignored in SCS mode.
3-16 XEROX MRP FAMILY COAX COMMAND REFERENCE