Xerox 6030 Copier User Manual


 
106 Main Menu XEROX WIDE FORMAT COPY SYSTEM
AUTOWIDTH/AUTOCENTER - Enables the automatic
centering of the image and automatic width detection. This
selection is the default. In this mode the document will be
prescanned.
PRODUCTIVITY - This feature does not use
AUTOCENTER, requiring the operator to manually align the
document within the media guidelines on the Feed-in Tray.
The width sensors eliminate the need for a prescan, thereby
increasing the overall throughput of the system resulting in
higher productivity. When this feature is used, the operator
must select the media series, ANSI, ARCH, ISO A, ISO B
JIS B and CUSTOM etc. since the number of sensors
provided cannot monitor every media type.
To use the MODE: PRODUCTIVITY: CUSTOM the custom
sizes must be entered in the CUSTOM MEDIA FORMATS
(Select the
Menu key > CONFIGURATION>COPY
OPTIONS).
To set the Scanner Control features:
1. Press the
Menu key. The MAIN MENU screen is displayed.
2. Press the
Enter key to select CONFIGURATION. The
CONFIGURATION menu screen is displayed.
3. Press the
Next key until SCANNER CONTROL is highlighted.
4. Press the
Enter key to select SCANNER CONTROL. The
SCANNER CONTROL screen is displayed.
SCANNER CONTROL
DOCUMENT RETURN:
AUTOSCAN
MODE:
FRONT
AUTOWIDTH/AUTOCENTER
9
ScannerControl Screen
5. Press the
Previous or Next key to select the desired feature.
6. Press the
Enter key to confirm the choice.
7. Press the
Previous or Next key to select the desired setting.
For AUTOSCAN, you can enable or disable the feature. A
checkmark in the box to the left of the feature indicates that
the feature is enabled. Enabled is the factory default setting
for these features.
For DOCUMENT RETURN, the selections are FRONT and
REAR. FRONT is the factory default setting.
For MODE: use the Previous or Next keys to select the
desired option then press the
Enter key to confirm the
choice. The options are MANUAL, AUTOWIDTH,
AUTOWIDTH/AUTOCENTER, or PRODUCTIVITY. If
PRODUCTIVITY is selected, then use the
Previous or Next
key to select the ANSI, ARCH, ISO A, ISO B, JISB, or
CUSTOM setting.