Filter
Top Products
29 604P15600
Before You Start
Verify the Ethernet connection is complete and the
desired speed is set. Then return to this page.
The information on this card will enable you to print with
the AppleTalk protocol from your Macintosh Computer.
Follow the steps as shown. The AppleTalk name for your
Xerox printer is set at the factory as the network
interface address of the printer. If you prefer not to set
the AppleTalk Name manually, you may use the PUtility
program found on the CentreWare Network Services
CD. Refer to the document supplied with your printer
entitled Getting Started with Network Services leaflet. for
details on how to install PUtility.
Record the following information:
AppleTalk Name ________________________
AppleTalk Zone ________________________
Go to the printer and...
1. Connect your printer to the network with the appro-
priate cabling.
2. Enter the Tools pathway
a) Press the Access ( or ) button.
b) On the keypad enter 1111 or the current
password. Press the Enter button when
finished.TheTouchScreenwillbeusedforthe
remainder of the data entry, unless instructed
otherwise.
3. Enable the AppleTalk protocol
a) Press the Connectivity and Network Setup
button.
b) Wait for the screen to refresh and press the
Network Setup button.
c) Press the AppleTalk button.
d) Press the Protocol and Media button.
e) Press the Enable button.
f) Press Save.
4. Assign a Name and Zone to your printer.
a) You will be returned to the previous screen.
Press the Name and Zone button.
b) At the next screen, press the Printer Name
button and enter the name you want for the
printer (this is the name that will appear in
the Chooser on your workstations) using the
touch panel keys. Press the Save button.
c) Press the Zone Name button, enter the
desired text for this item using the touch
panel keys, then press Save (the printer
default is * which means the printer will
appear in default zone). Press the Save
button again to return to the AppleTalk
Settings screen.
5. Exit the Tools Menu
a) Press the Exit Tools button.
Prepare for print driver installation
6. Print a Configuration Report. Repeat Steps 2a
and 2b.
a) Select System Setting.
b) Select Configuration Report.
c) Select Print Configuration Report Now.
d) Press the Cancel button.
e) Press the Exit Tools button.
7. Review the AppleTalk Settings: area of the
Configuration Report page and verify that
AppleTalk is enabled, the AppleTalk Name is
correct, and the AppleTalk Zone is correct (if
used).
a) From the documentation package supplied
with your printer, retrieve the CentreWare
Network Services Pack Proceed to the next
section of this procedure called Go to a
Workstation and...
Apple Macintosh (AppleTalk)