Xerox 6204 Copier User Manual


 
XEROX WIDE FORMAT COPY SYSTEM Getting to know the WIDE FORMAT COPY SYSTEM 31
The [Power Off] screen will display briefly on the control panel, and
then the control panel and the printer will shut down.
The controller will complete its shutdown within 30 seconds from the
moment the control panel and printer shut down. The controller’s
power button lamp will go out when the controller completes its
shutdown.
From the Web Print Management Tool
Select [Utilities] > Shutdown > [Shutdown].
The control panel, printer, and controller will undergo the same
power down process as described above.
3. Move the printer power switch to the off position.
4. Move the printer circuit breaker switch to the off position.
The Scan System requires about 45 seconds to warm up and initialize
after you power on the WIDE FORMAT COPY SYSTEM. Once the
initialization is complete, the READY screen is displayed. Below is an
example of the READY screen.
READY TO COPY
INSERT DOCUMENT
A
UTO
1
100.0 %
Ready to Copy Screen
You can now insert a document into the Document Feed Tray of the
Scan System. The Scan System will then transport the document to the
starting position. This transportation of the document is called staging.
If you cannot insert a document into the feed mechanism and achieve
staging after approximately 4 minutes, refer to the "Problem solving"
section of this guide.
Powering off the System
To power off the WIDE FORMAT COPY SYSTEM, do the following:
1. Power off the Controller and the Printer.
For the 8825/8830/8850/510 Series, switch the Circuit
Breaker Switch to the Off (O) position. Then switch the
Printer Switch to the Off (O) position.
For the 721P, first power off the Printer. Then power off the
Controller.
2. Switch off the Scan System by pressing the Power On/Off Switch
on the back of the Scan System to the Off (O) position as shown
below.
Scan System Warm-up
SCAN SYSTEM
Power Switch