Filter
Top Products
Xerox CopyCentre/WorkCentre 118 System Administration Guide 59
5EtherTalk
This chapter explains how to set up the machine to operate on an EtherTalk network.
The following information is provided.
Information Checklist – page 59
EtherTalk Environments – page 60
EtherTalk Installation – page 60
Installation Procedure – page 60
Network Communication Setup – page 60
Workstation Setup – page 62
Test Print – page 62
Information Checklist
Before installing EtherTalk on the machine, make sure that the following items are
available or have been performed.
If problems are encountered during the machine installation, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational EtherTalk network with Macintosh workstations
equipped with Ethernet network interface cards is required. These
procedures are not designed to install an EtherTalk network.
Customer
Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.2 Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Adobe PS print driver, or PPD (optional). Customer